Loc-Jaw Workholding System Features Knife-Edge and Blunt Edge Grippers with Over 6,000 lbs of Holding Force

The Loc-Jaw® system was conceived to simplify and allow greater tooling access and more versatility securing your parts when 4th and 5th axis machining.

The system is designed to hold raw stock without a pre-op using the carrier method, to penetrate material using the knife-edge grippers, and hold machined surfaces with the blunt-edge grippers.

Other benefits of the system include:

Blunt-edge grippers with #2 or #3 grit carbinite coating are recommended for high speed machining on hard alloys

Want more information? Click below.

Mitee-Bite

Rate this article

[Loc-Jaw Workholding System Features Knife-Edge and Blunt Edge Grippers with Over 6,000 lbs of Holding Force]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:


Type the number:



 

Copyright © 2022 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy ::m::