Large Diameter, Full-Grip Pie Jaws Stronger than Cast Aluminum

Dillon Manufacturing introduces pie jaws made from 6061 extruded aluminum now available up to 28-inches in diameter.

Machined from aluminum bar stock, these new large diameter full grip pie jaws are stronger and more reliable than cast aluminum, with none of the inherent porosity. Jaw heights of up to 10-inches are available.

They can also be made in diameters larger than the chuck, thus increasing the chucks capacity. Maximum contact area from the full grip jaws provides a solid gripping surface which yields more friction for drive with reduced part distortion. Custom designs available with special heights, diameters, and configurations, including a matching serration location which is exactly perpendicular to the slots.

Dillon full-grip chuck jaws are made in the USA with industry-leading lead-times, typically two weeks or less.

They are ideal for high-speed machining, as well as precision boring, tapping, drilling, and finishing across virtually all industrial markets. In addition to 6061 extruded aluminum, Dillon Full Grip Pie Jaws are available in brass, 1018 steel, and cast iron.

These wrap-around type top jaws distribute more of the gripping pressure across the workpiece, reducing part distortion. Dillon standard and custom full-grip jaws are available in 1.5MM x 60°, 3.0MM x 60°, 1/16 x 90°, or 3/32 x 90°serrations, American standard or tongue & groove, Acme, and square serrated key type mounting interfaces.

Want more information? Click below.

Dillon

Rate this article

[Large Diameter, Full-Grip Pie Jaws Stronger than Cast Aluminum]

Very interesting, with information I can use
Interesting, with information I may use
Interesting, but not applicable to my operation
Not interesting or inaccurate

E-mail Address (required):

Comments:


Type the number:



 

Copyright © 2022 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy ::m::