Return to Homepage

Wire EDM Features New Controller to Make Navigation Easier

MC Machinery's MV2400-ST wire EDM is specifically designed for larger-part production, capable of performing submerged cutting up to 16.5 inches deep.

With an annealing length of over 21 inches, this system can thread the maximum workpiece height both at the start point and through the gap if needed for a broken wire recovery. It also features the new Mitsubishi M800 series control with a 19-inch touchscreen -- providing easier user interface than previous models.

The M800 series control uses rotational and tilting functionality while showing job monitoring and important information in a single view. The new navigation interface provides smooth and easy job operation time for all operator expertise levels, allowing production jobs to be completed quickly and accurately.

MC Machinery will be showcasing the MV2400-ST, as well as the MCV-1000 machining center, at HOUSTEX 2019 in February.

Want more information? Click below.

MC Machinery

Return to Homepage

Copyright © 2019 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy ::m::