Return to Homepage

New Energy-Saving Welding Technique Could Make Future Cars Stronger

Engineers at Ohio State University have developed a new welding technique that consumes 80 percent less energy than a common welding technique, yet creates bonds that are 50 percent stronger.

The new welding technique could have a huge impact on the auto industry, which is poised to offer new cars that combine traditional heavy steel parts with lighter, alternative metals to reduce vehicle weight.

Vaporized foil actuator welding, a new technique developed for welding different materials, is performed using this assembly and "boom box" at The Ohio State University's Impulse Metalworking Lab.

 

 

 

 

Despite recent advances in materials design, alternative metals still pose a challenge to manufacturers in practice. Many are considered unweldable by traditional means, in part because high heat and re-solidification weaken them, said Glenn Daehn, professor of materials science and engineering at Ohio State, who helped develop the new technique.

"Materials have gotten stronger, but welds haven't. We can design metals with intricate microstructures, but we destroy the microstructure when we weld," he said.

"With our method, materials are shaped and bonded together at the same time, and they actually get stronger."

In VFA, a bright flash can be seen (above) when a burst of hot gas pushes two pieces of metal together at speeds approaching thousands of miles per hour. Smoke can be seen (below) just after the electrical pulse, which occurs within millionths of a second.

 

 

 

 

Daehn explained the new process in a keynote address at the Materials Science & Technology 2015 meeting held early October in Columbus.

In a common technique called resistance spot welding, manufacturers pass a high electrical current through pieces of metal, so that the metals' natural electrical resistance generates heat that partially melts them together and forms a weld. The drawbacks: generating high currents consumes a lot of energy, and the melted portions of metal are never as strong afterward as they were before.

Over the last decade, Daehn and his team have been trying to find ways around those problems. They've amassed more than half a dozen patents on a system called vaporized foil actuator (VFA) welding.

In VFA, a high-voltage capacitor bank creates a very short electrical pulse inside a thin piece of aluminum foil. Within microseconds (millionths of a second), the foil vaporizes, and a burst of hot gas pushes two pieces of metal together at speeds approaching thousands of miles per hour.

The VFA technique was used to weld these sheets of stainless steel and aluminum.

 

 

The pieces don't melt, so there's no seam of weakened metal between them. Instead, the impact directly bonds the atoms of one metal to atoms of the other. Seen under a high-powered microscope, the bond is actually quite beautiful, and often features delicate curlicues in spots where veins of both materials extend outward and wrap around each other.

The technique uses less energy because the electrical pulse is so short, and because the energy required to vaporize the foil is less than what would be required to melt the metal parts.

So far, the engineers have successfully bonded different combinations of copper, aluminum, magnesium, iron, nickel, and titanium. They have created strong bonds between commercial steel and aluminum alloys -- a feat that is impossible normally. Also, high-strength steel and aluminum join together with weld regions that are stronger than the base metals.

A quick demonstration by the team at the metalworking lab shows the strength of the new bond.

 

 

The technique is powerful enough to shape metal parts at the same time it welds them together, saving manufacturers a step.

Daehn and his team now want to join with manufacturers to further develop the technology, which will be licensed through Ohio State's Technology Commercialization Office.

Want more information? Click below.

VFA Welding

Watch Video

Return to Homepage

Copyright © 2017 by Nelson Publishing, Inc. All rights reserved. Reproduction Prohibited.
View our terms of use and privacy policy ::m::